Vicon MH 90S-SU-S-Twin
High output, low power requirement and cost effective
operation with a reduced number of tracks in the field, such
are the characteristics of Vicon's range of maize
choppers.
Trouble free chopping starts with a good cut
Clean cutting of the maize stems is the basis for an
even intake.
The Vicon system is tolerant of weeds and has a self cleaning
function. The adjustable point of the lower divider section acts
as a stationary knife to maintain best chop quality at any time.
Cutting discs are hardened and have a special protective coating
for maximum wear resistance.
Even intake for a precisely chopped crop
Two feed drums, a smooth and a toothed roller ensure that the
crop flows in a straight line to the flywheel, so stems, cobs
and husks are cut at right angles to exactly the preset length
of chop. The result is a homogeneous crop structure for top
quality silage.
MH 90S
The lower hitch bar of the MH 90 is continuously
adjustable in a range of 21 cm to be able to fit a wide range of
tractors up to 240 cm overall width. Power transmission via pto
drive shaft, V-belts and gears requires minimum maintenance.
Sharpening and readjusting the chopping wheel could not be
easier and faster. The discharge chute is hydraulically remote
controlled from the tractor driver's seat. An electric control
is also available as an extra.
MH 90SU
Identical in its basic design to the MH 90S, the MH
90SU has a facility that allows the chopping unit to be swung to
the rear. You will appreciate this advantage when negotiating
narrow field paths and gateways.
MH 90S Twin
Based on the single-row MH 90S, this two-row maize
chopper has an added weight of only 15%. It makes full use of
the tractor power available, but makes 50% less tracks in the
field.
Horse power requirement is minimal: 55 hp is sufficient for
chopping two rows in one single pass.
|
